Builders Edge 130120009020 Guia de Instalação

Consulte online ou descarregue Guia de Instalação para não Builders Edge 130120009020. Builders Edge 130120009020 Installation Guide Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 2
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 0
Mount Master
Installation Instructions
Part No. PAPC8559
-To be installed prior to siding-
Step 1
Remove the trim ring from the Mount Master Assembly.
See Figure 1 at right.
Figure 1
Step 3
Center the Mount Master over the outlet box. Be sure to place tape
or sealant between the Mount Master and the house. Attach the
Mount Master securely using an 8d nail or equivalent with a minimum
of four attachments. See Figure 3 at right. Note: The sheathing on the
illustration at right has been removed for clarity. The outlet box should
be in contact with the under side of the Mount Master.
Note: The use of a box extension (supplied by others) may be
required by your local or state electrical codes. Alternatively,
the box can be repositioned so that it contacts the underside
of the mount master.
CAUTION: All electrical connections must be in accordance with state and local codes,
ordinances, and the National Electrical Code. If you are unfamiliar with methods of
installing electrical wiring and devices, secure the services of a qualified licensed
electrician.
I-0015
4-30-07
MIPC9075
Step 2
Cut the desired opening in the Mount Master by cutting along
the patterns provided on the back of the part. See Figure 2
at right.
Note: Common sense, caution and care are factors which cannot be built into any product.
These conditions must be supplied by the person(s) installing the fixture.
Figure 3
Figure 2
ELEC.
BOX
BOX
EXTENSION
(IF USED)
MOUNT
MASTER
STUD
For use with standard and Insulated Siding
Series mount blocks.
Vista de página 0
1 2

Resumo do Conteúdo

Página 1 - Mount Master

Mount MasterInstallation InstructionsPart No. PAPC8559 -To be installed prior to siding-Step 1 Remove the trim ring from the Mount Master Assembly.

Página 2 - Figure 6

Step 4Cut the siding around the Mount Master. Install the siding according to the manufacturer's installation instructions. See Figure 4 at rig

Comentários a estes Manuais

Sem comentários